How to assign Static IP to TrackSo LAN Data Logger

The below method is applicable for loggers purchased between 2017-2021.

For loggers purchased post- 2022, Web UI is available for changing logger IP. Check here

Introduction

Multiple methods exists for assigning static IP to TrackSo LAN Data Loggers. You can choose any of the below method as per your convenience

Method-1 Via USB to RS232 Cable

1) Download and Install USB to RS232 Driver (Used for Connecting Laptop to Logger) – Link
Note: Download Version as per your OS (above link is suitable for Windows)

2) Connect TrackSo Data Logger to Laptop using USB to RS232 Cable.

3) Download and Run TrackSo Utility available at this- Link

Utility for devices purchased prior to 2021 is available here

4) Open the TrackSo Utility as below.

a) Check the COM port displayed in Utility. (If COM port is not displayed then either the USB to RS232 cable is not connected or Drivers are not installed
b) Update the User to admin
c) If the above steps are completed then Click on Connect.

5) Connect OK will be displayed once the connection is successful

6) Click ok Upload Config from Device to Load Current Config.
Note: If by mistake customer clicks on the button nearby whole device will get reset.

7) Change IP Configuration as required

8) Click on Download Config to Device.

Settings have been completed. Restart data logger and test

Method-2 Via DHCP enabled Router

By default when device is shipped the IP Configuration is DHCP.

1) Connect the device to any Router (Router should be in DHCP Mode
2) Open the admin page of the router and login (Example:admin page of router- 192.168.0.1)

3) Go to the list of currently connected devices

4) Router will display the IP Assigned to the Device.
Example Ip in above Screenshot- 192.168.0.118
5) Open the TrackSo Utility and change connection type to IP