Dynalabs Module Surface Temperature Sensor

Description

MODEL: DWMT 8104

Datasheet: https://trackso.in/wp-content/uploads/documents/2019/04/Dynalab-Weathertech-Datasheet-Installation-Guide-Surface-Module-Temperature-Sensor-DWMT-8104.pdf

Introduction :

• The module temperature sensor is used by PV plant operators to know the temperature of the modules installed in the array.
• The module temperature sensor converts this reading into a voltage signal.
• This signal is sent back to the monitoring device.
• As the system operator it’s important to know the systems’ performance.
• The module temperature sensor will help to enhance kWh performance by ensuring reliable access to the all necessary data.

Features

• Fast, Stable and accurate
• IP65 enclosure Excellent long term stability
• Onsite two point calibration
• Loop powered Calibration
• If using Modbus sensor then the PV Module Temperature Sensor is factory calibrated.
• If using analog output senor then use the following info to calibrate:
• Output – 0 to 5 VDC (-40 to 100 deg C)
• If the cable length is insufficient for the installation, additional cable can be added to the existing cable. If this is done, an accuracy de-rating factor must be added to the overall temperature accuracy of this sensor.